Limitations on Hierarchical Structures

In NW4C CreativeStudio Ver. 1.2.0 and later, you can assemble hierarchical structures for effects with a certain degree of freedom. However, with EffectMaker there are limitations on the hierarchical structures that are supported.

Here, we describe the hierarchical structures that can be loaded into Effect Maker and those that cannot.

• Loadable Hierarchical Structures
• Unloadable Hierarchical Structures

Loadable Hierarchical Structures

Data created using the hierarchical structures listed below is supported by Effect maker. The associated hierarchical structures can therefore be used.

• Emitter level immediately below the effect
  

• Effect and emitter not layered
  

Particle model nodes in NW4C CreativeStudio are handled by EffectMaker as effect entries.

In addition, emitter nodes and particle nodes in NW4C CreativeStudio are handled by EffectMaker as particle entries.

Unloadable Hierarchical Structures

Data created using the hierarchical structures listed below is note supported by Effect maker. The associated hierarchical structures therefore cannot be used.

• Effect level immediately below the emitter
  

• Same layer as the emitter
  

• Same layer as the effect
  

Data, such as the following, where nodes other than effects have been organized into a hierarchy, cannot be loaded.

• 3D model and effects hierarchies
• Camera and effect hierarchies
• Fog and effect hierarchies
• Light and effect hierarchies

CONFIDENTIAL