NetworkSetting

The NetworkSetting program configures security mode, SSID, and key (or passphrase) settings for network configurations 1-3.

Button	Operation
↑↓	Moves between slots to configure
A	Select / Run
B	Back / Cancel

Here you can set the network configuration of the selected slot. Select Write Setting to apply the settings.

Button	Operation
A	Select / Confirm
B	Back / Cancel
Touch Panel	Input of SSID and Key (or PassPhrase)

SecurityMode

Choose from the following: OPEN, WEP 40bit, WEP 104bit, WEP 128bit, WPA TKIP, WPA2 TKIP, WPA AES, and WPA2 AES.

SSID

Input an SSID via the software keyboard. You can only input single-byte alphanumeric characters. The setting has a maximum length of 32 characters.

KEY / PASS PHRASE

Input this data via the software keyboard.
If you chose OPEN, WEP 40bit, WEP 104bit, or WEP 128bit for the SecurityMode, input a key. If you chose WPA TKIP, WPA2 TKIP, WPA AES, or WPA2 AES, input a passphrase.

The maximum length of the string varies as shown below.

SecurityMode	Setting	Number of characters that can be input
OPEN	-	-
WEP 40-bit authentication.	KEY	Maximum 5 characters
WEP 104-bit authentication.	KEY	Maximum 13 characters
WEP 128-bit authentication.	KEY	Maximum 16 characters
WPA TKIP authentication.	PASS PHRASE	Minimum 8 characters - maximum 63 characters
WPA2 TKIP authentication.	PASS PHRASE	Minimum 8 characters - maximum 63 characters
WPA AES authentication.	PASS PHRASE	Minimum 8 characters - maximum 63 characters
WPA2 AES authentication.	PASS PHRASE	Minimum 8 characters - maximum 63 characters

Write Setting

Applies the settings.

Remove Setting

Deletes the settings.

2010/09/17

Initial version.