1. Introduction

The CTR-SDK contains the libraries, tools, and documentation required to develop CTR applications.

2. Notes

The source code for the libraries included in this package is intended for reference purposes during debugging. Note that the operation of these libraries is not guaranteed if they are rebuilt.

To use this package, you must run the corresponding System Updater (which is distributed as a separate package).

Programs built with the following SDKs will run on test units to which this System Updater is applied.

CTR-SDK 0.14.23, CTR-SDK 0.14.24
CTR-SDK 1.x
CTR-SDK 2.3.4
This version of the CTR-SDK

Programs built by, and tools included in, any version of the CTR-SDK other than those above will sometimes not run on development hardware to which this System Updater has been applied. Do not use this System Updater in combination with any such programs or tools.

For instructions on how to apply the System Updater, see SystemUpdater_Manual.pdf included in the System Updater Package.

Note that PARTNER-CTR version 2011/03/25 or later of the debugger software is required when using CTR-SDK 2.2 or a later version.

3. Confirmed Operating Environment

OS Microsoft Windows XP Professional Service Pack 3 (32-bit)
Microsoft Windows 7 Professional (64-bit)

Compiler ARM C/C++ Compiler, RVCT 4.0 b902 (2010/12/09)

Debugger PARTNER-CTR version 5.61 128 20110609

Runtime Microsoft .NET Framework 3.5 SP1

4. Installation Procedure

The separately released document CTR-StartupGuide.pdf explains the procedures for setting up the CTR-SDK, so be sure to read it beforehand.

5. How to Use the Build System

See the Build Rules page for more information about how to use the build system. The .NET Framework must be installed in order to perform a build.

6. Revision History

For a list of changes to each package, refer to the change log.

CONFIDENTIAL